Build Mufflers - Revision history

Marcin at 00:29, 19 June 2011

2011-06-19T00:29:18Z

← Older revision		Revision as of 00:29, 19 June 2011
Line 1:		Line 1:
	Added flexibility and accesssibility is created by using individual mufflers, at about $10 in parts per muffler, compared to a single muffler (more space constraints and $200 cost)		Added flexibility and accesssibility is created by using individual cylindrical mufflers, at about $10 in parts per muffler, compared to a single muffler (more space constraints and $200 cost)

	*Cut inner tube - 6.5"		*Cut inner tube - 6.5"

Marcin at 00:29, 19 June 2011

2011-06-19T00:29:07Z

← Older revision		Revision as of 00:29, 19 June 2011
Line 1:		Line 1:
			Added flexibility and accesssibility is created by using individual mufflers, at about $10 in parts per muffler, compared to a single muffler (more space constraints and $200 cost)

	*Cut inner tube - 6.5"		*Cut inner tube - 6.5"
	*Cut outer tube - 8"		*Cut outer tube - 8"

Marcin: Created page with "Cut inner tube - 6.5" Cut outer tube - 8" Secure 8 close nips, 1” Secure 8 elbows, 1” Cut 2 rings – flange and end piece of large tube Grind and ream rings *Prepare ..."

2011-06-19T00:27:25Z

Created page with "*Cut inner tube - 6.5" *Cut outer tube - 8" *Secure 8 close nips, 1” *Secure 8 elbows, 1” *Cut 2 rings – flange and end piece of large tube *Grind and ream rings *Prepare ..."

New page

*Cut inner tube - 6.5"
*Cut outer tube - 8"
*Secure 8 close nips, 1”
*Secure 8 elbows, 1”
*Cut 2 rings – flange and end piece of large tube
*Grind and ream rings
*Prepare 1 washer – 1/2” - for closing inner tube
*Prepare 1 closure of washer
*Mark pattern for muffler flange
*Torch muffler flange, use #1 torch head
*Weld muffler assembly starting with muffler flange - threaded into elbow to protect threads from welding
*Weld inner tube to second close nip
*Weld inner tube flange
*Weld closure of inner tube, close off inner tube by welding
*Weld outer tube to flange, then close off outer tube
*Attach muffler to engine, with an allan-head 5/16"x3/4" bolt for the inner bolt (because of inaccessibility), and a regular hex head bolt to outer flange hole, with metal lock washers on both bolts

[[Category:Fabrication Procedures]]

Build Mufflers - Revision history

Marcin at 00:29, 19 June 2011

Marcin at 00:29, 19 June 2011

Marcin: Created page with "*Cut inner tube - 6.5" *Cut outer tube - 8" *Secure 8 close nips, 1” *Secure 8 elbows, 1” *Cut 2 rings – flange and end piece of large tube *Grind and ream rings *Prepare ..."

Marcin: Created page with "Cut inner tube - 6.5" Cut outer tube - 8" Secure 8 close nips, 1” Secure 8 elbows, 1” Cut 2 rings – flange and end piece of large tube Grind and ream rings *Prepare ..."