YK: Created page with "=Soldering Stepper Driver Pins= *Insert the short end of the male headers into the stepper driver board from the bottom, then pressfit the headers into the small breadboard for ..."

2012-03-31T01:07:36Z

Created page with "=Soldering Stepper Driver Pins= *Insert the short end of the male headers into the stepper driver board from the bottom, then pressfit the headers into the small breadboard for ..."

New page

=Soldering Stepper Driver Pins=

*Insert the short end of the male headers into the stepper driver board from the bottom, then pressfit the headers into the small breadboard for holding.

*Apply flux to all header connections

*Apply solder to the tip of the soldering iron

*Solder header connections at opposite corners of the stepper driver board for stability, reapplying solder to and cleaning the soldering iron tip as necessary; repeat for the remaining header connections.

=Wiring=

[[Image: Electronics.jpg]]

CNCCMV2/Electronics - Revision history

YK: Created page with "=Soldering Stepper Driver Pins= *Insert the short end of the male headers into the stepper driver board from the bottom, then pressfit the headers into the small breadboard for ..."