Chris F: Created page with "{{GVCS Header}} Universal Rotor Small lathe chuck 1.5"x14"x1" hydraulic cylinder (Factor e Farm) Coupler - to go from 1-7/8 shaft to 1-1/4" shaft. 2" long on wider side..."

2011-09-20T02:31:43Z

Created page with "{{GVCS Header}} *Universal Rotor *Small lathe chuck *1.5"x14"x1" hydraulic cylinder (Factor e Farm) *Coupler - to go from 1-7/8 shaft to 1-1/4" shaft. 2" long on wider side..."

New page

{{GVCS Header}}

*[[Universal Rotor]]
*Small lathe chuck
*1.5"x14"x1" hydraulic cylinder (Factor e Farm)
*Coupler - to go from 1-7/8 shaft to 1-1/4" shaft. 2" long on wider side, 1" long on narrower side
*[2] 3/8"x4"x6" angle, 44" long - verticals
*[4] 1/4"x1" angle, 20" long - rails for holding universal rotor to prevent it from twisting
*[2] 3/8"x4"x6" angle, 12" long
*[1] 3/4" threaded rod, 8"; [4] nuts - for top-facing end of cylinder
*[1] 3/4" threaded rod, 6"; [4] nuts - for bottom-facing end of cylinder
*[2] 1/4"x2" angle, 4" long - mounts for top-facing end of cylinder
*[2] 1/4"x2" angle, 2" long - mounts for bottom-facing end of cylinder
*[4] 1/2"x3"x15" bar - for table clamps
*[2] 1/2"x3"x7" bar - for table clamps
*[4] 1"x4" bolts - for table clamps
*[4] 1" nuts - for table clamps

Total: $150 in metal from local fab shop

Plus base:
*[2] 6"x7/8" u-channel, 3 feet long ($56)
*[2] 1/4"x2" angle, 2 foot long ($12)

Total budget: '''about $200 for structure''', excluding chuck and Universal Rotor

{{GVCS Footer}}

Drill Press/Bill of Materials - Revision history

Chris F: Created page with "{{GVCS Header}} *Universal Rotor *Small lathe chuck *1.5"x14"x1" hydraulic cylinder (Factor e Farm) *Coupler - to go from 1-7/8 shaft to 1-1/4" shaft. 2" long on wider side..."

Chris F: Created page with "{{GVCS Header}} Universal Rotor Small lathe chuck 1.5"x14"x1" hydraulic cylinder (Factor e Farm) Coupler - to go from 1-7/8 shaft to 1-1/4" shaft. 2" long on wider side..."