VDP at 10:45, 27 September 2013

2013-09-27T10:45:56Z

← Older revision		Revision as of 10:45, 27 September 2013
Line 20:		Line 20:

	References:		References:
	{{reflist}}}}		{{reflist}}

VDP: Schematic of a heat pump system that uses a rainwater pit as a heat sink. The rainwater can be used at the house for showering (as indicated here), washing hands, flushing the flush toilets (if present), ... Note that the rainwater is herefore connecte...

2013-09-27T10:45:32Z

New page

Schematic of a heat pump system that uses a rainwater pit as a heat sink. The rainwater can be used at the house for showering (as indicated here), washing hands, flushing the flush toilets (if present), ... Note that the rainwater is herefore connected to the cold water tap of the fossets. This is also why the pipe is connected so low in the rainwater pit.

The heat pump shown here is a ground-source heat pump (ground/water-source heat pump to be exact as it transfers his heat to water which is used in the radiators in the house). <ref>https://en.wikipedia.org/wiki/File:Heatpump.svg Schematic of compression heat pump</ref><ref>[http://www.ecovisionsystems.co.uk/uploads/images/extra/groundsourceheatpump.gif Heat pump schematic]</ref>The heat pump shown has it's heat exchanger dug very shallowly into the soil (1,5m or so). This reduces groundwork, and also makes sense for using it with a rainwater pit (to act as a buffer) as the heat of soil fluctuates greatly at this shallow depth in temperate countries, depending on the season. Note that an air-source heat pump (air/water-source heat pump to be exact) can also be used in this setup but is only efficient in countries where it warms up greatly during the day but where it is cool at night, during the entire year. The heat pump would in both cases be fitted with a printed circuit board (PCB) connected to a temperature sensor. The sensor would continuously monitor the temperature of the ground (in the first case) or the air (in the latter case) and if this temperature is high enough, activate the circulation pumps and compressor. If the temperature is too low, it will make sure the circulation pumps and compressor are deactivated.

The solar thermal collector indicated is not essential yet helps to warm up the rainwater pit.

*A: rainwater pit with lid; the rainwater is meant to work as a heat sink and the water itself is also still used around the house
*B: cold water supply (rainwater)
*C: heat exchanger
*D: evaporator
*E: condenser
*F: compressor
*G: metering device
*H: heat exchanger
*I: solar thermal collector
*J: heat exchanger
*K: heat exchanger
*L: radiator
* the green blocks marked in the schematic represent (mostly circulation) pumps

References:
{{reflist}}}}

File:Heat pump system on rainwater pit.png - Revision history

VDP at 10:45, 27 September 2013

VDP: Schematic of a heat pump system that uses a rainwater pit as a heat sink. The rainwater can be used at the house for showering (as indicated here), washing hands, flushing the flush toilets (if present), ... Note that the rainwater is herefore connecte...