Framed PowerCube Module - Revision history

KhalidH at 22:49, 27 December 2013

2013-12-27T22:49:07Z

← Older revision		Revision as of 22:49, 27 December 2013
Line 4:		Line 4:

	For now, There is extra height (4") is left on the design so that if we decide that we want the PowerCube to be removed out of the side of the structural frame instead of out of the top, we have that option of raising the 4' tube up 4".		For now, There is extra height (4") is left on the design so that if we decide that we want the PowerCube to be removed out of the side of the structural frame instead of out of the top, we have that option of raising the 4' tube up 4".
			[[category:Power Cube]]

Lucas Warner at 17:50, 15 June 2013

2013-06-15T17:50:18Z

← Older revision		Revision as of 17:50, 15 June 2013
Line 1:		Line 1:
			[[File:PowerCube Module (15 Jun '13).skp]]

	The XYZ is not completely closed off in this drawing because this is what would be removed from the MicroTrac. The tube that is missing from this drawing would be "left behind" as part of the frame of the MicroTrac. The 48" tubes (one on each side) will have to be added as needed in other applications.		The XYZ is not completely closed off in this drawing because this is what would be removed from the MicroTrac. The tube that is missing from this drawing would be "left behind" as part of the frame of the MicroTrac. The 48" tubes (one on each side) will have to be added as needed in other applications.

	For now, There is extra height (4") is left on the design so that if we decide that we want the PowerCube to be removed out of the side of the structural frame instead of out of the top, we have that option of raising the 4' tube up 4".		For now, There is extra height (4") is left on the design so that if we decide that we want the PowerCube to be removed out of the side of the structural frame instead of out of the top, we have that option of raising the 4' tube up 4".

Lucas Warner: Created page with " The XYZ is not completely closed off in this drawing because this is what would be removed from the MicroTrac. The tube that is missing from this drawing would be "left behi..."

2013-06-15T17:37:38Z

Created page with " The XYZ is not completely closed off in this drawing because this is what would be removed from the MicroTrac. The tube that is missing from this drawing would be "left behi..."

New page

The XYZ is not completely closed off in this drawing because this is what would be removed from the MicroTrac. The tube that is missing from this drawing would be "left behind" as part of the frame of the MicroTrac. The 48" tubes (one on each side) will have to be added as needed in other applications.

For now, There is extra height (4") is left on the design so that if we decide that we want the PowerCube to be removed out of the side of the structural frame instead of out of the top, we have that option of raising the 4' tube up 4".