StefanL38 at 21:09, 1 January 2012

2012-01-01T21:09:09Z

← Older revision		Revision as of 21:09, 1 January 2012
Line 1:		Line 1:
	Who am I?		Who I am

	not familiar with layouting WIki-pages as you can see from the non-existant layout of this page		not familiar with layouting WIki-pages as you can see from the non-existant layout of this page
Line 17:		Line 17:
	development environment is very easy to setup:		development environment is very easy to setup:

	1) Start ~~Steup~~.exe for FTDI-driver		1) Start Setup.exe for FTDI-driver

	2) Start Setup.exe for Code-Editor.		2) Start Setup.exe for Code-Editor.

StefanL38: Created page with "Who am I? not familiar with layouting WIki-pages as you can see from the non-existant layout of this page 43 yeras old. I have a degree similar to a bachelor (Dipl.-Ing.) in me..."

2012-01-01T19:47:20Z

Created page with "Who am I? not familiar with layouting WIki-pages as you can see from the non-existant layout of this page 43 yeras old. I have a degree similar to a bachelor (Dipl.-Ing.) in me..."

New page

Who am I?

not familiar with layouting WIki-pages as you can see from the non-existant layout of this page

43 yeras old. I have a degree similar to a bachelor (Dipl.-Ing.) in mechanical engineering.
My daily work is working as a teacher in mathematics and metal technology (basic things about milling, lathhing, water-heatings steel-construction).

I'm a "hobby" electronic "engineer". No formal examination but quite a good amount of knowledge.

I have software-developing experience with turbo-pascal (long time ago) and delphi.
I worked several years for a company as a softwaredeveloper for industrial controls of engraving machines.

I write code for the microcontroller called propeller-chip [http://www.parallax.com/tabid/407/Default.aspx] from parallax inc.

This is my favorite microcontroller for the following reasons:

development environment is very easy to setup:

1) Start Steup.exe for FTDI-driver

2) Start Setup.exe for Code-Editor.

Start coding in a high-level-language called SPIN (similar to C or delphi) or propeller-assembler PASM

'''EACH''' PASM command can be executed conditional to flags

Code runs completely in RAM so selfmodifiying code is possible.

32Bit at 80MHz clock

Chip has TV-graphic and VGA-graphic "on board". (add some resistors and you are done)

Has 8 CPU-cores than can run independant from each other

So no interrupts for catching external events nescessary.

absolute deterministic behaviour of the PASM-code.

Very flexible as all interfacing is done by software.

hundreds of Ready to use code-modules for

PS/2-keyboard, VGA-signal generation, TV-signal-generation

I²C, onewire, SPI, serial COM-Port, TCP/IP-stack and a lot more see [http://obex.parallax.com]

Stefan Ludwig - Revision history

StefanL38 at 21:09, 1 January 2012

StefanL38: Created page with "Who am I? not familiar with layouting WIki-pages as you can see from the non-existant layout of this page 43 yeras old. I have a degree similar to a bachelor (Dipl.-Ing.) in me..."