Marcin: Created page with "=Polish Crew via Cohabitat= Please see our Open Source CNC Torch table work - we have a CNC torch table that is a copy of this: http://www.youtube.com/watch?v=yTzDtb3oKX4&li..."

2013-05-12T00:09:49Z

Created page with "=Polish Crew via Cohabitat= Please see our Open Source CNC Torch table work - we have a CNC torch table that is a copy of this: http://www.youtube.com/watch?v=yTzDtb3oKX4&li..."

New page

=Polish Crew via Cohabitat=

Please see our Open Source CNC Torch table work - we have a CNC torch table that is a copy of this:

http://www.youtube.com/watch?v=yTzDtb3oKX4&list=PL95BF12B1E4560744&index=3

That one shown is running on a controller from http://www.candcnc.com/ - and we want to open source the design.

We need the ability to run about 3-4 amps of current. We eventually need to reach 10 amps or so at 50 volts.

Please see our Extreme Design sprints - and maybe you can join us next Friday/Saturday? If not, I would like to communicate to build upon your work on open source stepper motor controllers.

Stepper Motor Controller Emails - Revision history

Marcin: Created page with "=Polish Crew via Cohabitat= Please see our Open Source CNC Torch table work - we have a CNC torch table that is a copy of this: http://www.youtube.com/watch?v=yTzDtb3oKX4&li..."