Talk:D3D CNC Torch Table - Revision history

Dorkmo: /* Printed part */

2018-08-01T16:31:38Z

Printed part

← Older revision		Revision as of 16:31, 1 August 2018
Line 14:		Line 14:

	could make a part that slips on the two rods, and has groove off to the side that holds steel plate. Wouldnt require cutting holes or different bolts.		could make a part that slips on the two rods, and has groove off to the side that holds steel plate. Wouldnt require cutting holes or different bolts.

			<nowiki>
			difference(){
			cube([2.75,5,5]);
			translate([.75,4,0])
			cylinder(r=0.5, h=5, $fn=36);
			translate([.75,1,0])
			cylinder(r=0.5, h=5, $fn=36);
			translate([.5,2,0])
			cube([.5,1,5]);

			translate([1.75,.75,0])
			cube([.5,3.5,5]);

			}
			</nowiki>

Dorkmo: /* Flat Bar */

2018-08-01T15:52:09Z

Flat Bar

← Older revision		Revision as of 15:52, 1 August 2018
Line 10:		Line 10:

	[[Image:D3dcnc-changes1.png\|400px]]		[[Image:D3dcnc-changes1.png\|400px]]

			===Printed part===

			could make a part that slips on the two rods, and has groove off to the side that holds steel plate. Wouldnt require cutting holes or different bolts.

Dorkmo: Created page with "=Design Change Suggestions= ==Flat Bar== I think it would be straight forward and beneficial to add a piece of flat bar (sized about 1/4" x 6") from end to end of the long a..."

2017-11-08T03:57:39Z

Created page with "=Design Change Suggestions= ==Flat Bar== I think it would be straight forward and beneficial to add a piece of flat bar (sized about 1/4" x 6") from end to end of the long a..."

New page

=Design Change Suggestions=

==Flat Bar==

I think it would be straight forward and beneficial to add a piece of flat bar (sized about 1/4" x 6") from end to end of the long axis. the sliding part could be tweaked to add a roller bearing to support it self from the flat bar. could bolt a piece of angle iron near the bottom to prevent flexing if needed. --[[User:Dorkmo|Dorkmo]] ([[User talk:Dorkmo|talk]]) 04:57, 8 November 2017 (CET)

[[Image:D3dcnc-changes2.png|400px]]

[[Image:D3dcnc-changes1.png|400px]]