View source for Power Cube 7S Suggestions for Product Release

Tom,

re: [[File:PCSF.skp]]

1. Please use a pump interface plate just like engine interface plate. This can be CNC cut and allows for easier alignment + replacement of pump if the large bolt holes have play bc we use say a 3/4" bolt.

2. Move the hydraulic tank interconnect down by about 1" - or as low as allowed.

3. In order to stack 4 of these horizontally, we can arrange the 4 power cubes such that the hudraulic outlets are going 2 to the side and 2 to the back. If we do this, then the top fuel tank + hydraulic tank mounts must be below 8 inches from the top so the tube does not hit the tank mount (which sticks out a little) when 4 power cubes are put together. This just affects the location of the top tank mounts, and the bottom tank mount should be truncated a little so the tube does not hit it either. Can you see this? 

I think this is looking good. We can currently stack 4 of these - 2 horizontal and 2 vertical; or 4 horizontal, if you make the above corrections.