LifeTrac II Fabrication Procedure: Difference between revisions
Jump to navigation
Jump to search
(Created page with 'Frame') |
No edit summary |
||
| Line 1: | Line 1: | ||
Frame | =Frame= | ||
As a general rule, all the measurements I have listed here will be more accurate if you mark the centre on each tube and then measure the "holes" from the centre our as opposed to from the ends in case some tubes are not cut the the exact lenghs. | |||
*[4] 92"×4"×4" Tubes for base. | |||
**2 base tubes - 13/16" (V) holes 2" from ends. 1 (V) hole 4" front of centre. 4 (E,W) holes for wheel plates 9" & 13" from ends. | |||
** | |||
[[Category:LifeTrac II]] | |||
Revision as of 21:23, 3 July 2010
Frame
As a general rule, all the measurements I have listed here will be more accurate if you mark the centre on each tube and then measure the "holes" from the centre our as opposed to from the ends in case some tubes are not cut the the exact lenghs.
- [4] 92"×4"×4" Tubes for base.
- 2 base tubes - 13/16" (V) holes 2" from ends. 1 (V) hole 4" front of centre. 4 (E,W) holes for wheel plates 9" & 13" from ends.