LifeTrac II Fabrication Procedure: Difference between revisions
Jump to navigation
Jump to search
No edit summary |
No edit summary |
||
| Line 1: | Line 1: | ||
=Frame= | =Frame= | ||
As a general rule, all the measurements I have listed here will be more accurate if you mark the centre on each tube and then measure the "holes" from the centre | As a general rule, all the measurements I have listed here will be more accurate if you mark the centre on each tube and then measure the "holes" from the centre out as opposed to from the ends in, in case some tubes are not cut the the exact lenghs. | ||
*[4] 92"×4"×4" Tubes for base. | *[4] 92"×4"×4" Tubes for base. | ||
Revision as of 21:24, 3 July 2010
Frame
As a general rule, all the measurements I have listed here will be more accurate if you mark the centre on each tube and then measure the "holes" from the centre out as opposed to from the ends in, in case some tubes are not cut the the exact lenghs.
- [4] 92"×4"×4" Tubes for base.
- 2 base tubes - 13/16" (V) holes 2" from ends. 1 (V) hole 4" front of centre. 4 (E,W) holes for wheel plates 9" & 13" from ends.