LifeTrac II Fabrication Procedure: Difference between revisions
Jump to navigation
Jump to search
No edit summary |
No edit summary |
||
| Line 5: | Line 5: | ||
Key - (V) = Vertical. (E,W) = East,West. (N,S) = North South. | Key - (V) = Vertical. (E,W) = East,West. (N,S) = North South. | ||
*[4] 92"×4"×4" Tubes for base. | *[4] 92"×4"×4" Tubes for base. | ||
**2 inner base tubes - 13/16" (V) holes 2" from ends. 1 (V) hole 4" front of centre. 4 (E,W) holes for wheel plates 9" & 13" from ends. | **[2] inner base tubes - 13/16" (V)holes 2" from ends. 1 (V)hole 4" front of centre. 4 (E,W)holes for wheel plates 9" & 13" from ends. 2 (V)holes 13-1/2" & 22-1/2" behind centre, 1-1/4" from outer edge. | ||
**2 outer base tubes - | **[2] outer base tubes - | ||
[[Category:LifeTrac II]] | [[Category:LifeTrac II]] | ||
Revision as of 21:46, 3 July 2010
Frame
As a general rule, all the measurements I have listed here will be more accurate if you mark the centre of each tube and then measure the "holes" from the centre out as opposed to from the ends in, in case some tubes are not cut to the exact lengths.
Key - (V) = Vertical. (E,W) = East,West. (N,S) = North South.
- [4] 92"×4"×4" Tubes for base.
- [2] inner base tubes - 13/16" (V)holes 2" from ends. 1 (V)hole 4" front of centre. 4 (E,W)holes for wheel plates 9" & 13" from ends. 2 (V)holes 13-1/2" & 22-1/2" behind centre, 1-1/4" from outer edge.
- [2] outer base tubes -