LifeTrac II Fabrication Procedure

Frame

As a general rule, all the measurements I have listed here will be more accurate if you mark the centre of each tube and then measure the "holes" from the centre out as opposed to from the ends in, in case some tubes are not cut to the exact lengths.

Key - (V) = Vertical. (E,W) = East,West. (N,S) = North South.

13/16" drill bit used for 3/4" bolts.

• [4] 92"×4"×4" Tubes for base.
  • [2] Outer base tubes - 13/16" (V)holes 2" from ends. (V)holes 4" front of centre. (E,W)holes for wheel plates 9" & 13" from ends. (V)holes for hydraulic base plate 13-1/4" & 22-3/4" behind centre, 1-1/4" from outer edge.
  • [2] Inner base tubes - (V)holes 2" form ends. (V)hole 4" front of centre. (E,W)holes 6", 9" & 13" from ends & (E,W)holes in centres. (V)holes for hydraulic base plate 13-1/4" & 22-3/4" behind centre, 1-1/4" from inner edge.

• [3] 60" Under base tubes.
  • (V)holes 2" & 10" from ends.
  • (N,S)holes 14" form ends.

• [2] 55" Front vertical tubes.
  • (E,W)holes 2" form top & 2", 6" & 9" from bottom.
  • (N,S)holes 6" from top & 5" from bottom.

• [2] 52" Centre vertical tubes.
  • (E,W)holes 2" from top & 6" from bottom.
  • (N,S)holes 6" from top & 2" from bottom.

• [2] 59" Rear vertical tubes.
  • (E,W)holes 6" from top & 2", 6" & 9" from bottom.
  • (N,S)holes 2" from top & 5" from bottom.

• [3] 44" Top (E,W) tubes.
  • (V)holes 2" from ends.
  • (N,S)holes 6" from ends.

• [2] 84" Top (N,S) tubes.
  • (E,W)holes 2" from ends & in centre.
  • (v)holes 6" from ends & 4" from of centre