PowerCube Fuel tank: Difference between revisions
Jump to navigation
Jump to search
Tom Griffing (talk | contribs) (Created page with "=====Fuel tank===== *[2] ¼” x 4” x 8” Plates *4” x 8” x 14 ½” Tube *¼” x 2” x 24” Plate * All welds assembling the tank must be quality welds, as they must...") |
(No difference)
|
Revision as of 03:55, 12 December 2011
Fuel tank
- [2] ¼” x 4” x 8” Plates
- 4” x 8” x 14 ½” Tube
- ¼” x 2” x 24” Plate
- All welds assembling the tank must be quality welds, as they must not leak. Be careful not to “over weld” the tank to the mount.
- Clean the inside of the ¼” x 4” x 8” tube and the two ¼” x 4” x 8” plates – anything left on these surfaces will end up in the gasoline and could clog the engine when started. Tack and weld the plates on each end of the tube, taking care to orient the top plate with the filler hole as shown in the diagram below.
- Weld the 1/4” tank flange to the smaller hole.
