CEB Press/User's Manual/Testing: Difference between revisions
(Created page with "'''1''' Tools 2 Computer 2 USB Cable 2 CEB Press '''1''' Steps 2 Upload the CEB Testing Code http://opensourceecology.org/wiki/CEB_Press/Manufacturing_Instructions/Code_Upl...") |
No edit summary |
||
| (One intermediate revision by the same user not shown) | |||
| Line 6: | Line 6: | ||
2 CEB Press | 2 CEB Press | ||
'''1''' Code | |||
2 CEB Testing Python Code V2 Annotated | |||
http://opensourceecology.org/wiki/File:CEBTesting.txt | |||
'''1''' Steps | '''1''' Steps | ||
| Line 17: | Line 23: | ||
2 Within the CEB Testing Python GUI (Graphical User Interface), click "open connection". If connection is not established, check that the port name in the Arduino IDE Tools>Serial Port matches the port name within the CEB Testing Code near the beginning. | 2 Within the CEB Testing Python GUI (Graphical User Interface), click "open connection". If connection is not established, check that the port name in the Arduino IDE Tools>Serial Port matches the port name within the CEB Testing Code near the beginning. | ||
2 GUI Testing Instructions - | 2 GUI Testing Instructions - For passive testing (without hydraulic power), listen for the solenoid ticks and LED arrows lighting up. For active testing (with hydraulic power), keep the cylinders unjammed. | ||
3 | 3 | ||
Latest revision as of 20:05, 28 December 2011
1 Tools
2 Computer
2 USB Cable
2 CEB Press
1 Code
2 CEB Testing Python Code V2 Annotated
http://opensourceecology.org/wiki/File:CEBTesting.txt
1 Steps
2 Upload the CEB Testing Code
http://opensourceecology.org/wiki/CEB_Press/Manufacturing_Instructions/Code_Upload
2 Run the CEB Testing Python Code
2 Within the CEB Testing Python GUI (Graphical User Interface), click "open connection". If connection is not established, check that the port name in the Arduino IDE Tools>Serial Port matches the port name within the CEB Testing Code near the beginning.
2 GUI Testing Instructions - For passive testing (without hydraulic power), listen for the solenoid ticks and LED arrows lighting up. For active testing (with hydraulic power), keep the cylinders unjammed.
3
MOSFET 3 = Primary Cylinder Down
MOSFET 6 = Primary Cylinder Up
MOSFET 9 = Secondary Cylinder Left
MOSFET 10 = Secondary Cylinder Right
MOSFET 11 = Shaker Spin
LED = Arduino LED
Sensor = All Sensors Are Read at Medium Frequency (check Arduino IDE serial monitor for the observed analog values)
2 Toggle off the controller box to stop the CEB Press electronic influence on the hydraulic system (all solenoids return to open center, all work ports offline).