CNCCMV2/Electronics: Difference between revisions
< CNCCMV2
Jump to navigation
Jump to search
(Created page with "=Soldering Stepper Driver Pins= *Insert the short end of the male headers into the stepper driver board from the bottom, then pressfit the headers into the small breadboard for ...") |
(No difference)
|
Latest revision as of 01:07, 31 March 2012
Soldering Stepper Driver Pins
- Insert the short end of the male headers into the stepper driver board from the bottom, then pressfit the headers into the small breadboard for holding.
- Apply flux to all header connections
- Apply solder to the tip of the soldering iron
- Solder header connections at opposite corners of the stepper driver board for stability, reapplying solder to and cleaning the soldering iron tip as necessary; repeat for the remaining header connections.
Wiring
