Cold Saw/V1 Design Parameters/Clamp System: Difference between revisions
Jump to navigation
Jump to search
(→Shafts) |
|||
Line 34: | Line 34: | ||
=Shafts= | =Shafts= | ||
*'''Diameter: 12mm''' | |||
*'''Length: 250mm''' | |||
=Threaded Rod= | =Threaded Rod= |
Revision as of 21:48, 20 May 2012
Clamp Axis Holes
- Clamp Axis Centerline Height: 25mm
- Spacing Along Length: 25mm, 75mm, 125mm
- Shaft Hole Diameter: 12mm
- Threaded Rod Hole Diameter: 12mm
Fixed Block
- Length: 150mm
- Width: 75mm
- Height: 50mm
- Mount Spacing Along Length: 40mm, 110mm
- Mount Spacing Along Width: 15mm, 60mm
- Mount Hole Diameter: 12mm
Moving Block
- Length: 150mm
- Width: 50mm
- Height: 75mm
Clamp Jaws
Shafts
- Diameter: 12mm
- Length: 250mm