Cold Saw/V1 Design Parameters/Clamp System: Difference between revisions
Jump to navigation
Jump to search
| Line 46: | Line 46: | ||
=Shaft Collars= | =Shaft Collars= | ||
*'''Outside Diameter: 25mm''' | |||
*'''Inside Diameter: 12mm''' | |||
*'''Length: 20mm''' | |||
*'''Setscrew: M12''' | |||
=Thrust Washer= | =Thrust Washer= | ||
=Handle= | =Handle= | ||
Revision as of 21:52, 20 May 2012
Clamp Axis Holes
- Clamp Axis Centerline Height: 25mm
- Spacing Along Length: 25mm, 75mm, 125mm
- Shaft Hole Diameter: 12mm
- Threaded Rod Hole Diameter: 12mm
Fixed Block
- Length: 150mm
- Width: 75mm
- Height: 50mm
- Mount Spacing Along Length: 40mm, 110mm
- Mount Spacing Along Width: 15mm, 60mm
- Mount Hole Diameter: 12mm
Moving Block
- Length: 150mm
- Width: 50mm
- Height: 75mm
Clamp Jaws
Shafts
- Diameter: 12mm
- Length: 250mm
Threaded Rod
- Thread: M12
- Length: 350mm
Shaft Collars
- Outside Diameter: 25mm
- Inside Diameter: 12mm
- Length: 20mm
- Setscrew: M12