Cold Saw/V1 Design Parameters/Support System: Difference between revisions
Jump to navigation
Jump to search
| Line 53: | Line 53: | ||
=Support Shaft= | =Support Shaft= | ||
*'''Length: | *'''Length: 250mm''' | ||
*'''Diameter: 31.8mm''' | *'''Diameter: 31.8mm''' | ||
Revision as of 01:30, 22 May 2012
Shaft Block
- Length: 75mm
- Width: 50mm
- Height: 75mm
- Support Shaft Hole Diameter: 31.8mm
- Support Shaft Hole Spacing Along Length: 37.5mm
- Support Shaft Hole Spacing Along Height: 50mm
- Mount Hole Diameter: 12mm
- Mount Hole Spacing Along Length: 10mm, 65mm
- Mount Hole Spacing Along Width:25mm
Support Bar
- Length: 150mm
- Width: 75mm
- Thickness: 25mm
- Mount Hole Diameter: 31.8mm
- Mount Hole Spacing Along Length: 30mm
- Mount Hole Spacing Along Width: 40mm
- Interface Hole Diameter: 12mm
- Interface Hole Spacing Along Length: 90mm, 120mm
- Inteface Hole Spacing Along Width: 20mm, 60mm
Bridge Bar
- Length: 50mm
- Width: 75mm
- Thickness: 25mm
Support Shaft
- Length: 250mm
- Diameter: 31.8mm
Support Shaft Collar
- Length: 30mm
- Outside Diameter: 60mm
- Bore: 31.8mm
- Setscrew Type: M12
Support Thrust Washer
- Outside Diameter: 60mm
- Inside Diameter: 35mm
- Length: 4mm