Cold Saw/V1 Design Parameters/Drive System

Hydraulic Motor

• Length (excluding shaft): 240mm

• Width (excluding mounting section): 100mm

• Height: 100mm

• Mounting Section Width: 135mm

• Mounting Section Thickness: 20mm

• Mount Hole Pattern: 40mm x 100mm

• Mount Hole Diameter: 12.7mm

Interface Plate

• Length: 230mm

• Width: 75mm

• Thickness: 25mm

• Drive Hole Diameter: 40mm

• Drive Hole Spacing Along Length: 70mm

• Drive Hole Spacing Along Width: 40mm

• Motor Mount Hole Spacing Along Length: 20mm, 120mm

• Motor Mount Hole Spacing Along Width: 20mm, 60mm

• Motor Mount Hole: 12mm

• Interfacing Hole Spacing Along Length: 180mm, 210mm

• Interfacing Hole Spacing Along Width: 20mm, 60mm

• Interface Hole: M12

Shaft Coupling

• Outside Diameter: 50.8mm

• Bore: 32mm

• Length: 75mm

• Setscrew Hole Diameter: 6.8mm

• Setscrew Hole Thread: M8x1.25

• Setscrew Hole Spacing Along Length: 25mm

• Length Enclosing Hydraulic Motor Shaft: 38.26mm

Drive Setscrew

• Thread: M8x1.25

• Length: 10mm

Mount Disc

• Shape: Round Plate

• Outside Diameter: 120mm

• Inside Diameter: 32mm

• Thickness: 12.7mm

• Number of Pinholes: 2

• Pinhole Diameter: 8mm

• Pinhole Distance from Center: 45mm

Pin

• Diameter: 8mm

• Length: 50mm

Spindle

• Outside Diameter: 31.8mm"

• Length: 90mm

• End Thread Length: 40mm

• End Thread: 1-1/4"-7

• Length Inserted Into Shaft Coupling: 25mm

Spindle Nut

• Thread: 1-1/4"-7

• Width: 47.6mm

• Height: 27mm

Blade

• Bore: 32mm

• Diameter: 355.6mm

• Thickness: 3mm

• Number of Pinholes: 2

• Pinhole Diameter: 8mm

• Pinhole Distance from Center: 45mm

Blade Guard Support

• Shape: Bent Flat Bar

• Thickness: 3.175mm

• Width: 25.4mm

• Length:

• Bend 45 degrees at XXmm

• Bend XX degrees at XXmm

Operation Handle

• Shape: Round Bar

• Diameter: 25.4mm

• Length: XXmm