Cold Saw/V1 Design Parameters/Drive System: Difference between revisions

From Open Source Ecology
Jump to navigation Jump to search
(Blanked the page)
 
(60 intermediate revisions by the same user not shown)
Line 1: Line 1:
=Hydraulic Motor=


*'''Mount Hole Pattern: 40mm x 100mm'''
*'''Mount Hole Diameter: 12.7mm'''
=Interface Plate=
*'''Length: 200mm'''
*'''Width: 75mm'''
*'''Thickness: 25mm'''
*'''Motor Mount Hole Spacing Along Length: 20mm, 120mm'''
*'''Motor Mount Hole Spacing Along Width: 20mm, 60mm'''
*'''Motor Mount Hole: 12mm'''
*'''Interfacing Hole Spacing Along Length: 150mm, 180mm'''
*'''Interfacing Hole Spacing Along Width: 20mm, 60mm'''
*'''Interface Hole: M12'''
=Shaft Coupling=
*'''Outside Diameter: 51.4mm'''
*'''Bore: 31.8mm'''
*'''Length: 75mm'''
*'''Setscrew Hole Diameter: (4mm Hex)'''
*'''Setscrew Hole Spacing Along Length: 25mm'''
=Inside Plate=
*'''Length:
*'''Width:
*'''Thickness:
*'''
=Outside Plate=
=Spindle=
*'''Outside Diameter: 1.25"'''
*'''Length: XX'''
=Blade=
*'''Bore: 1.25"'''
*'''Diameter: XX'''

Latest revision as of 22:54, 23 May 2012

Retrieved from "https://wiki.opensourceecology.org/index.php?title=Cold_Saw/V1_Design_Parameters/Drive_System&oldid=63327"