Cold Saw/V1 Design Parameters/Drive System: Difference between revisions

From Open Source Ecology
Jump to navigation Jump to search
(Blanked the page)
 
(38 intermediate revisions by the same user not shown)
Line 1: Line 1:
=Hydraulic Motor=


*'''Mount Hole Pattern: 40mm x 100mm'''
*'''Mount Hole Diameter: 12.7mm'''
[http://www.surpluscenter.com/item.asp?item=9-7469&catname=hydraulic Surplus Center Information]
=Interface Plate=
*'''Length: 230mm'''
*'''Width: 75mm'''
*'''Thickness: 25mm'''
*'''Drive Hole Diameter: 40mm'''
*'''Drive Hole Spacing Along Length: 70mm'''
*'''Drive Hole Spacing Along Width: 40mm'''
*'''Motor Mount Hole Spacing Along Length: 20mm, 120mm'''
*'''Motor Mount Hole Spacing Along Width: 20mm, 60mm'''
*'''Motor Mount Hole: 12mm'''
*'''Interfacing Hole Spacing Along Length: 180mm, 210mm'''
*'''Interfacing Hole Spacing Along Width: 20mm, 60mm'''
*'''Interface Hole: M12'''
=Shaft Coupling=
*'''Outside Diameter: 51.4mm'''
*'''Bore: 32mm'''
*'''Length: 75mm'''
*'''Setscrew Hole Diameter: 6.8mm
*'''Setscrew Hole Thread: M8x1.25'''
*'''Setscrew Hole Spacing Along Length: 25mm'''
=Blade Mount Disc=
*'''Shape: Round Plate'''
*'''Outside Diameter: 100mm'''
*'''Inside Diameter: 32mm'''
*'''Thickness: 12.7mm'''
*'''Pinhole Diameter: XXmm'''
*'''Pinhole Pattern, 2 holes, from Center: XXmm'''
=Pin=
*'''Diameter: XXmm'''
*'''Length: XXmm'''
=Spindle=
*'''Outside Diameter: 31.8mm"'''
*'''Length: 75mm'''
*'''End Thread Length: 25mm'''
*'''End Thread: 1-1/4", 7 TPI'''
=Spindle Nut=
*'''Thread: 1-1/4", 7 TPI'''
*'''Outside Diameter: XXmm'''
*'''Width: XXmm'''
=Blade=
*'''Bore: 31.8mm"'''
*'''Diameter: 254mm'''
*'''Thickness: 3mm'''
*'''Pinhole Diameter: XXmm'''
*'''Pinhole Pattern from center: XXmm, XXmm'''

Latest revision as of 22:54, 23 May 2012

Retrieved from "https://wiki.opensourceecology.org/index.php?title=Cold_Saw/V1_Design_Parameters/Drive_System&oldid=63327"