RepRap and Electronics Fabrication Router Specifications: Difference between revisions
Jump to navigation
Jump to search
(New page: =General= *0.3 mm accuracy *1 liter per hour printing volume capacity *Component cost of $300 for DIY fabrication =Flexibility= *Tool holder adaptable to microcircuit fabrication, there...) |
|||
| Line 7: | Line 7: | ||
=Flexibility= | =Flexibility= | ||
*Tool holder adaptable to microcircuit fabrication, | *Tool holder adaptable to microcircuit fabrication, therefore it could make its own control circuit | ||
**Plastic extruder head is replaced with small router to etch circuits from boards | |||
*Also adaptable to solid state laser head, so it could do circuits via lithography? | |||
*Connecting rods extrudable on a small scale, see [[Metal Extrusion Specifications]] | *Connecting rods extrudable on a small scale, see [[Metal Extrusion Specifications]] | ||
*Basic design should be extendable to smaller and larger RepRap versions | |||
[[Category:Specifications]] | [[Category:Specifications]] | ||
Revision as of 02:00, 5 March 2009
General
- 0.3 mm accuracy
- 1 liter per hour printing volume capacity
- Component cost of $300 for DIY fabrication
Flexibility
- Tool holder adaptable to microcircuit fabrication, therefore it could make its own control circuit
- Plastic extruder head is replaced with small router to etch circuits from boards
- Also adaptable to solid state laser head, so it could do circuits via lithography?
- Connecting rods extrudable on a small scale, see Metal Extrusion Specifications
- Basic design should be extendable to smaller and larger RepRap versions