D3D Fusion printer design: Difference between revisions

Latest revision as of 23:41, 7 January 2016

Redirect to:

@@ Line 1: / Line 1: @@
-= Ideas =
+#REDIRECT [[D3D Printer Design]]
-== Making it modular ==
-Much like Alexander Stepanenko has done for CNCs here:
-<html><iframe width="560" height="315" src="https://www.youtube.com/embed/wkk4zv96Dvo" frameborder="0" allowfullscreen></iframe></html>
-This would allow extending to a multi purpose machine at a later stage. Examples of existing multi purpose machines are Diyouware[http://www.diyouware.com/] and Fabtotum Fabricator[http://fabtotum.com/about].
-== CoreXZ ==
-This means driving the X/Z directions by rotating two motors in same/opposite directions. The idea has been tested with good results[http://forums.reprap.org/read.php?2,377858].
-The big win with this configuration is saving one motor (compare to current common designs that uses 2 motors for Z axis) and much easier build (thread and bearings replace threaded rod with nut).
-== CoreXYZ ==
-There's nothing hindering us from also driving a Y axis with lines, like shown here:
-<html><iframe width="560" height="315" src="https://www.youtube.com/embed/ceBZMyg3n3M" frameborder="0" allowfullscreen></iframe></html>
-Again, saving in a Y-axis belt and motor makes it an easier build. Using v-groove bearings and dynema line for driving all axes also takes down the unique part count really low.