CEB Press/Manufacturing Instructions/Arms - primary: Difference between revisions

From Open Source Ecology
Jump to navigation Jump to search
No edit summary
 
(43 intermediate revisions by 7 users not shown)
Line 1: Line 1:
{{Category=CEB press building instructions}}
[[Image:Farmewitharms.jpg|thumb]]
 
=Part Information=
 
The primary arms attach the cylinder/frame assembly to the secondary arms, which support it. They also attach to the Brickholder Plate, the Dirt-Keeper Plate, the Controller Mount, and the Valve Mount.


[[Image:Farmewitharms.jpg|thumb]]
=Tools=
 
*Hole punch with 3/4" die
 
*Measuring Tape
 
*Metal Marking Utensil


== Tools Required ==
=Materials=


Hole punch with 13/16" and 3/4" dyes
*[2] Steel Angle 4" A by 6" B, 1/2" Thickness, 72" Length


== Materials Required ==
=Steps=


*4 pieces 72" long - 4"x6"x3/8" angle steel
*Mark and punch holes as shown below.


== Diagrams ==
Left


[[Image:LeftPrimaryArm.png|700px]]


== Fabrication Steps ==
Right
Punch the 3/4" holes and then the 13/16" holes.


The holes are all to be punched in the 4" side of the angle iron,  in 1 1/4" from the edge of it. The 3/4" holes are located 2" and 70" from one end of the angle iron. The two arms will be mirror images of one another.  
[[Image:RightPrimaryArm.png|700px]]


The 13/16" hole centers are located at 15, 31, 37, 39 5/8, 48 3/8, 53, and 64" from one end of the angle iron. The outer ones (2" and 70") should be 3/4". (This is so that there is no play allowed between the primary and secondary arms).  Make the two arms  mirror images of one another.
*Label arms as left and right from the perspective of an observer looking at the CEB Press from the ejection side.

Latest revision as of 02:36, 23 December 2011

Farmewitharms.jpg

Part Information

The primary arms attach the cylinder/frame assembly to the secondary arms, which support it. They also attach to the Brickholder Plate, the Dirt-Keeper Plate, the Controller Mount, and the Valve Mount.

Tools

  • Hole punch with 3/4" die
  • Measuring Tape
  • Metal Marking Utensil

Materials

  • [2] Steel Angle 4" A by 6" B, 1/2" Thickness, 72" Length

Steps

  • Mark and punch holes as shown below.

Left

File:LeftPrimaryArm.png

Right

File:RightPrimaryArm.png

  • Label arms as left and right from the perspective of an observer looking at the CEB Press from the ejection side.
Retrieved from "https://wiki.opensourceecology.org/index.php?title=CEB_Press/Manufacturing_Instructions/Arms_-_primary&oldid=49147"