RepRap and Electronics Fabrication Router Specifications: Difference between revisions

From Open Source Ecology
Jump to navigation Jump to search
(Redirected page to RepRap)
 
(2 intermediate revisions by 2 users not shown)
Line 1: Line 1:
=General=
#REDIRECT [[RepRap]]
 
*0.3 mm accuracy
*1 liter per hour printing volume capacity for the amount of material deposited
*Component cost of $300 for DIY fabrication
*Controlled by open source software
 
=Flexibility=
 
*Tool holder adaptable to microcircuit fabrication, therefore it could make its own control circuit
**Plastic extruder head is replaced with small router to etch circuits from boards
*Also adaptable to solid state laser head, so it could  do circuits via lithography?
*Connecting rods extrudable on a small scale, see [[Metal Extrusion Specifications]]
*Basic design should be extendable to smaller and larger RepRap versions
 
[[Category:Specifications]]

Latest revision as of 16:36, 7 November 2010

Redirect to:

Retrieved from "https://wiki.opensourceecology.org/index.php?title=RepRap_and_Electronics_Fabrication_Router_Specifications&oldid=15611"