D3D v18.04 Software: Difference between revisions
Jump to navigation
Jump to search
| Line 9: | Line 9: | ||
=To Get Proper Prints with a New Extruder= | =To Get Proper Prints with a New Extruder= | ||
#Verify e-steps for the extruder - and make sure Cura machine settings are consistent. | #Verify e-steps for the extruder - and make sure Cura machine settings are consistent. | ||
#Test extruder - so it's extruding correctly with Cura interface | |||
=Software= | =Software= | ||
Revision as of 21:51, 24 May 2018
Background
There are 6 places where software may be configured when developing new versions of the OSE 3D Printer:
- Marlin -
- Configuration file (.ini) in Cura.
- Start and end g-codes in Cura - contained in configuration file
- Machine Settings in Cura - contains bed size, z offset, number of extruders, presence of heated bed. And - E steps per mm of filament.
- Print parameters in Cura - contained in configuration file
To Get Proper Prints with a New Extruder
- Verify e-steps for the extruder - and make sure Cura machine settings are consistent.
- Test extruder - so it's extruding correctly with Cura interface
Software
Marlin
- D3D v18.04 Marlin is updated for a geared extruder - see - File:OSE Marlin.zip