Revision as of 18:26, 25 May 2018

Background

There are 5 places where software may be configured when developing new versions of the OSE 3D Printer. The Cura used here is D3D Lulzbot Cura.

Marlin - versions after April 23, 2018 work - File:OSE Marlin.zip
Configuration file (.ini) in Cura - File:D3D Profile.ini. May 24, 2018 version.
Start and end g-codes in Cura - contained in configuration file
Machine Settings in Cura - contains bed size, z offset, number of extruders, presence of heated bed. And - E steps per mm of filament. This is the only place to set presence of heated bed.
Print parameters in Cura - contained in configuration file -

Note also that EEPROM Settings may affect the way that the 3D printer works.

Machine settings currently on OSE Linux v1.0 - heated bed needs to be turned on:

Note that G Codes in the Cura interface do not appear to override the G Codes from Marlin. Does this have to do with EEPROM settings? How are EEPROM Settings relevant?

Verify e-steps for the extruder - and make sure Cura machine settings are consistent.
Test extruder - so it's extruding correctly with Cura interface

@@ Line 7: / Line 7: @@
 #'''Machine Settings in Cura''' - contains bed size, z offset, number of extruders, presence of heated bed. And - E steps per mm of filament. '''This is the only place to set presence of heated bed.'''
 #'''Print parameters in Cura''' - contained in configuration file -
+Note also that [[EEPROM Settings]] may affect the way that the 3D printer works.
 =Notes=