CEB Press/Manufacturing Instructions/Hopper sheet metal: Difference between revisions
Jump to navigation
Jump to search
(→Steps) |
(→Steps) |
||
| Line 36: | Line 36: | ||
[[Image:hopper_layout.jpg|1000px]] | [[Image:hopper_layout.jpg|1000px]] | ||
*Insert then weld the 1/2" bolts to the side hopper plates such that the bolt heads would be inside if the hopper were to be assembled. | |||
[[Image:boltshingeplates.jpg|500px|The bolts ready to weld]] | |||
*Punch 3/4" holes in 4 of the hinge plates as shown. | *Punch 3/4" holes in 4 of the hinge plates as shown. | ||
| Line 45: | Line 49: | ||
[[Image:weldinghingeplates.jpg|500px|Welding the hinge plates]] | [[Image:weldinghingeplates.jpg|500px|Welding the hinge plates]] | ||
*Weld the | *Weld the no-hole plates of the plate-hinge-plate assemblies to the sides of the front and rear hopper plates. | ||
Revision as of 04:33, 23 December 2011
Tools
- Torch
- Welder
- Hole punch with 3/4" dies
Materials
- [12] Door Hinges
- [12] 1/2" x 1 1/2" bolts
- [12] 1/2" washers (12)
- [12] 1/2" lockwashers (12)
- [12] 1/2" nuts (12)
- Steel plate 5' x 10' x 1/8" OR [2] Steel plate 4' x 8' x 1/8"
- Steel bar 3" x 1/8" x 24'
Steps
- Torch the hopper shapes as shown. Grind away any excess slag. Punch all of the holes shown.
- Insert then weld the 1/2" bolts to the side hopper plates such that the bolt heads would be inside if the hopper were to be assembled.
- Punch 3/4" holes in 4 of the hinge plates as shown.
- Weld a holey hinge plate, a non-holey hinge plate and 3 hinges together as shown. Repeat for a total of 4 holeplate-3hinge-noholeplate welded assemblies. Note to make sure the side of the assembly that sticks out most is on the top; this way it won't interfere with the hopper metal below when installing the hopper.
- Weld the no-hole plates of the plate-hinge-plate assemblies to the sides of the front and rear hopper plates.