Cold Saw/V1 Design Parameters/Drive System: Difference between revisions
Jump to navigation
Jump to search
| Line 4: | Line 4: | ||
*'''Mount Hole Diameter: 12.7mm''' | *'''Mount Hole Diameter: 12.7mm''' | ||
[http://www.surpluscenter.com/item.asp?item=9-7469&catname=hydraulic Surplus Center Information] | |||
=Interface Plate= | =Interface Plate= | ||
Revision as of 23:21, 21 May 2012
Hydraulic Motor
- Mount Hole Pattern: 40mm x 100mm
- Mount Hole Diameter: 12.7mm
Interface Plate
- Length: 230mm
- Width: 75mm
- Thickness: 25mm
- Drive Hole Diameter: 40mm
- Drive Hole Spacing Along Length: 70mm
- Drive Hole Spacing Along Width: 40mm
- Motor Mount Hole Spacing Along Length: 20mm, 120mm
- Motor Mount Hole Spacing Along Width: 20mm, 60mm
- Motor Mount Hole: 12mm
- Interfacing Hole Spacing Along Length: 180mm, 210mm
- Interfacing Hole Spacing Along Width: 20mm, 60mm
- Interface Hole: M12
Shaft Coupling
- Outside Diameter: 51.4mm
- Bore: 31.8mm
- Length: 75mm
- Setscrew Hole Diameter: (4mm Hex)
- Setscrew Hole Spacing Along Length: 25mm
Inside Plate
- Length: 75mm
- Width: 75mm
- Thickness: 12mm
- Drive Hole Spacing: 37.5mm, 37.5mm
- Pinhole Pattern from center: XXmm, XXmm
Outside Plate
- Length: 75mm
- Width: 75mm
- Thickness: 12mm
- Drive Hole Spacing: 37.5mm, 37.5mm
- Pinout Pattern from center: XXmm, XXmm
Spindle
- Outside Diameter: 1.25"
- Length: 75mm
- End Thread Length: 25mm
- End Thread: 1-1/4", 7 TPI
Blade
- Bore: 1.25"
- Diameter: 250mm
- Pinhole Pattern from center: XXmm, XXmm