Cold Saw/V1 Design Parameters/Support System: Difference between revisions
Jump to navigation
Jump to search
| Line 1: | Line 1: | ||
=Shaft Block= | =Shaft Block= | ||
*'''Length: | *'''Length: 75mm''' | ||
*'''Width: | *'''Width: 50mm''' | ||
*'''Height: | *'''Height: 50mm''' | ||
*''' | |||
=Support Bar= | =Support Bar= | ||
Revision as of 01:50, 21 May 2012
Shaft Block
- Length: 75mm
- Width: 50mm
- Height: 50mm
Support Bar
- Length: 150mm
- Width: 75mm
- Thickness: 25mm
- Mount Hole Diameter: 31.8mm
- Mount Hole Spacing Along Length: 30mm
- Mount Hole Spacing Along Width: 40mm
- Interface Hole Diameter: 12mm
- Interface Hole Spacing Along Length: 90mm, 120mm
- Inteface Hole Spacing Along Width: 20mm, 60mm
Bridge Bar
- Length: 50mm
- Width: 75mm
- Thickness: 25mm
Support Shaft
- Length: 200mm
- Diameter: 31.8mm
Support Shaft Collar
- Length: 30mm
- Outside Diameter: 60mm
- Bore: 31.8mm
- Setscrew Type: M12