Cold Saw/V1 Design Parameters/Support System: Difference between revisions

From Open Source Ecology
Jump to navigation Jump to search
Line 45: Line 45:
=Bridge Bar=
=Bridge Bar=


*'''Length: 50mm'''
*'''Length: 25mm'''


*'''Width: 75mm'''
*'''Width: 75mm'''

Revision as of 01:50, 22 May 2012

Shaft Block

  • Length: 75mm
  • Width: 50mm
  • Height: 75mm


  • Support Shaft Hole Diameter: 31.8mm
  • Support Shaft Hole Spacing Along Length: 37.5mm
  • Support Shaft Hole Spacing Along Height: 50mm


  • Mount Hole Diameter: 12mm
  • Mount Hole Spacing Along Length: 10mm, 65mm
  • Mount Hole Spacing Along Width:25mm

Support Bar

  • Length: 150mm
  • Width: 75mm
  • Thickness: 25mm


  • Mount Hole Diameter: 31.8mm
  • Mount Hole Spacing Along Length: 30mm
  • Mount Hole Spacing Along Width: 40mm


  • Interface Hole Diameter: 12mm
  • Interface Hole Spacing Along Length: 90mm, 120mm
  • Inteface Hole Spacing Along Width: 20mm, 60mm

Bridge Bar

  • Length: 25mm
  • Width: 75mm
  • Thickness: 25mm

Support Shaft

  • Length: 250mm
  • Diameter: 31.8mm

Support Shaft Collar

  • Length: 30mm
  • Outside Diameter: 60mm
  • Bore: 31.8mm
  • Setscrew Type: M12

Support Thrust Washer

  • Outside Diameter: 60mm
  • Inside Diameter: 35mm
  • Length: 4mm
Retrieved from "https://wiki.opensourceecology.org/index.php?title=Cold_Saw/V1_Design_Parameters/Support_System&oldid=63174"