Cold Saw/V1 Design Parameters/Drive System: Difference between revisions
Jump to navigation
Jump to search
| Line 65: | Line 65: | ||
*'''Pinhole Pattern, 2 holes, from Center: XXmm''' | *'''Pinhole Pattern, 2 holes, from Center: XXmm''' | ||
=Spindle= | =Spindle= | ||
Revision as of 23:28, 22 May 2012
Hydraulic Motor
- Mount Hole Pattern: 40mm x 100mm
- Mount Hole Diameter: 12.7mm
Interface Plate
- Length: 230mm
- Width: 75mm
- Thickness: 25mm
- Drive Hole Diameter: 40mm
- Drive Hole Spacing Along Length: 70mm
- Drive Hole Spacing Along Width: 40mm
- Motor Mount Hole Spacing Along Length: 20mm, 120mm
- Motor Mount Hole Spacing Along Width: 20mm, 60mm
- Motor Mount Hole: 12mm
- Interfacing Hole Spacing Along Length: 180mm, 210mm
- Interfacing Hole Spacing Along Width: 20mm, 60mm
- Interface Hole: M12
Shaft Coupling
- Outside Diameter: 51.4mm
- Bore: 31.8mm
- Length: 75mm
- Setscrew Hole Diameter: 6.8mm
- Setscrew Hole Thread: M8x1.25
- Setscrew Hole Spacing Along Length: 25mm
Inside Plate
- Shape: Round Plate
- Outside Diameter: 100mm
- Inside Diameter: 31.8mm
- Thickness: 12.7mm
- Pinhole Diameter: XXmm
- Pinhole Pattern, 2 holes, from Center: XXmm
Spindle
- Outside Diameter: 31.8mm"
- Length: 75mm
- End Thread Length: 25mm
- End Thread: 1-1/4", 7 TPI
Blade
- Bore: 31.8mm"
- Diameter: 254mm
- Thickness: 5mm
- Pinhole Pattern from center: XXmm, XXmm