Hole Connector: Difference between revisions
Jump to navigation
Jump to search
No edit summary |
|||
| Line 8: | Line 8: | ||
[[Image:holeconnector.png|500px]] | [[Image:holeconnector.png|500px]] | ||
=Examples= | |||
[[Image: waterproofcablefitting.png|500px]] | |||
[[Image: waterproofcablefitting2.png|500px]] | |||
Revision as of 21:04, 6 September 2012
Summary
The objective is a waterproof, corrosion-resistant, chemical-resistant, impact-resistant, redeployable device that mounts onto the material surrounding a hole and allows electrical transmission through that hole.
The hole connector applies tension with an elastic, fine contact material on the cross-sectional perimeter of a transmission line that passes through the hole.
The hole connector is made with a double-end male thread with an inner diameter(hydraulic nipple). A nut and O-ring are used to mount and seal one thread end to the case wall's hole.
Examples
