Hall Effect Sensor Module: Difference between revisions
Jump to navigation
Jump to search
| Line 2: | Line 2: | ||
=Action Info= | =Action Info= | ||
Materials | |||
[https://www.sparkfun.com/products/9312 Hall Effect Sensor] | [https://www.sparkfun.com/products/9312 Hall Effect Sensor] | ||
| Line 10: | Line 12: | ||
22 AWG Stranded Wire of different colours | 22 AWG Stranded Wire of different colours | ||
Cord jacket for 3 22AWG wires | |||
Wire Label | |||
---- | |||
Steps | |||
*Cut 3 pieces of 22AWG wire and 1 piece of jacket to the desired length (ex. 150cm) | |||
*Strip the 3 pieces of wire 10mm at one end and 20mm at the other end | |||
*Check and confirm which pins of the hall effect sensor are to which inputs/outputs (ex. V+, V-, Signal) | |||
*Solder and shrink tube the 10mm ends of the wires to the hall effect sensor pins and attach a label near the sensor to each wire about what the wire's pin is (ex. Red is V+, Black is V-, Green is Signal) | |||
* | |||
=Developers= | =Developers= | ||
Yoonseo Kang - ykang404@gmail.com | Yoonseo Kang - ykang404@gmail.com | ||
Revision as of 21:17, 2 October 2012
Introduction
Action Info
Materials
Aluminum Bar 6061T6 1/4" x 1/2" x 72"
22 AWG Stranded Wire of different colours
Cord jacket for 3 22AWG wires
Wire Label
Steps
- Cut 3 pieces of 22AWG wire and 1 piece of jacket to the desired length (ex. 150cm)
- Strip the 3 pieces of wire 10mm at one end and 20mm at the other end
- Check and confirm which pins of the hall effect sensor are to which inputs/outputs (ex. V+, V-, Signal)
- Solder and shrink tube the 10mm ends of the wires to the hall effect sensor pins and attach a label near the sensor to each wire about what the wire's pin is (ex. Red is V+, Black is V-, Green is Signal)
Developers
Yoonseo Kang - ykang404@gmail.com