Tooling Plate: Difference between revisions
Jump to navigation
Jump to search
(→Build) |
|||
| Line 23: | Line 23: | ||
=Build= | =Build= | ||
Mill and drill the heck out of the plate. | Mill and drill the heck out of the plate: | ||
---- | |||
Use roughing endmill. | |||
(ex. 1/2" dia 4 flute) | |||
Make 18/32" wide, 0.6" deep slots across the length of the iron bar | |||
Spacing from long edge: | |||
---- | |||
Use T-slot cutter. | |||
Match or be a bit less than the depth of the slot. Make the T-slot across the length of the iron bar. | |||
Spacing from long edge: same as last step | |||
---- | |||
Revision as of 03:32, 4 November 2012
Introduction
Design
T-slots
Holes
Mounting interface to machine? Assuming screw-down.
Tools
Mcmaster T-slot Cutter: 8789A12
Materials
Cold-rolled iron rectangular bar
25mm x 150mm x 300mm is about 9kg. Iron density = 7.87g/cm3
Build
Mill and drill the heck out of the plate:
Use roughing endmill.
(ex. 1/2" dia 4 flute)
Make 18/32" wide, 0.6" deep slots across the length of the iron bar
Spacing from long edge:
Use T-slot cutter.
Match or be a bit less than the depth of the slot. Make the T-slot across the length of the iron bar.
Spacing from long edge: same as last step