User:Paulne: Difference between revisions
Jump to navigation
Jump to search
No edit summary |
No edit summary |
||
| Line 9: | Line 9: | ||
[https://github.com/fluidfred/powerlolu] | [https://github.com/fluidfred/powerlolu] | ||
Schematic seems ok(Eagle format). Board file seems unfinished. Powerlolu drive capability is 10A. | Schematic seems ok(Eagle format). Board file seems unfinished. Powerlolu drive capability is 10A. | ||
[[ | [[Media:180px-RAMPS1-3 6pos.JPG]] | ||
Revision as of 22:06, 13 July 2013
Plasma Torch
Ramps 1.4 Heater circuit to be used for oxygen solenoid. Connector is a 6 terminal screw terminal block. Uses bare wire for connection. Solenoid voltage must be same as stepper voltage supplied to ramps board. Typically 12 or 24 volts DC. Media:180px-RAMPS1-3 6pos.JPG
Stepper motors are 425 oz.in 4 volt 2.8 amp. This exceeds the 1-1.5A capability of the ramps Pololu drivers. Decision has been made to use the Powerlolu board at [1] Schematic seems ok(Eagle format). Board file seems unfinished. Powerlolu drive capability is 10A. Media:180px-RAMPS1-3 6pos.JPG