User:Paulne: Difference between revisions
No edit summary |
No edit summary |
||
| Line 10: | Line 10: | ||
Schematic seems ok(Eagle format). Board file seems unfinished. Powerlolu drive capability is 10A. | Schematic seems ok(Eagle format). Board file seems unfinished. Powerlolu drive capability is 10A. | ||
[[Media:Powerlolu_web_preview_featured.jpg]] | [[Media:Powerlolu_web_preview_featured.jpg]] | ||
This board does not directly attach to the ramps board, but uses 4 wires to attach to one of the sockets | This board does not directly attach to the ramps board, but uses 4 wires to attach to one of the sockets that the Pololu board plugs into on the ramps board. | ||
Note #1 - This is not very mechanically or electrically stable. | Note #1 - This is not very mechanically or electrically stable. | ||
Note #2 - The Powerlolu board is not current limited or fused. The power supply to the board should have an inline fuse no greater than 10A. | Note #2 - The Powerlolu board is not current limited or fused. The power supply to the board should have an inline fuse no greater than 10A. | ||
Revision as of 22:21, 13 July 2013
Plasma/Acetylene Cutter
Ramps 1.4 Heater circuit to be used for oxygen solenoid. Connector is a 6 terminal, screw terminal block. Use bared wire for connection. Solenoid voltage must be same as stepper voltage supplied to ramps board. Typically 12 or 24 volts DC. Media:180px-RAMPS1-3 6pos.JPG
Stepper motors are 425 oz.in 4 volt 2.8 amp. This exceeds the 1-1.5A capability of the ramps Pololu drivers. Decision has been made to use the Powerlolu board at [1] Schematic seems ok(Eagle format). Board file seems unfinished. Powerlolu drive capability is 10A. Media:Powerlolu_web_preview_featured.jpg This board does not directly attach to the ramps board, but uses 4 wires to attach to one of the sockets that the Pololu board plugs into on the ramps board. Note #1 - This is not very mechanically or electrically stable. Note #2 - The Powerlolu board is not current limited or fused. The power supply to the board should have an inline fuse no greater than 10A.
