Drill Press: Difference between revisions
Jump to navigation
Jump to search
| Line 8: | Line 8: | ||
*Universal Rotor (Factor e Farm) | *Universal Rotor (Factor e Farm) | ||
*Small lathe chuck (Factor e Farm) | *Small lathe chuck (Factor e Farm) | ||
*1.5"x14"x1" hydraulic cylinder (Factor e Farm) | |||
*Coupler - to go from 1-7/8 shaft to 1-1/4" shaft. 2" long on wider side, 1" long on narrower side | |||
*[2] 3/8"x4"x6" angle, 44" long - verticals | *[2] 3/8"x4"x6" angle, 44" long - verticals | ||
*[4] 1/4"x1" angle, | *[4] 1/4"x1" angle, 20" long - rails for holding universal rotor to prevent it from twisting | ||
*[2] 3/8"x4"x6" angle, 12" long | *[2] 3/8"x4"x6" angle, 12" long | ||
*[1] 3/4" threaded rod, 8"; [4] nuts - for top-facing end of cylinder | |||
*[1] 3/4" threaded rod, 6"; [4] nuts - for bottom-facing end of cylinder | |||
* | * | ||
[[Category:RepLab]] | [[Category:RepLab]] | ||
Revision as of 20:48, 25 June 2010
See Open Pario to download design file - http://openpario.mime.oregonstate.edu/projects/drillpress/documents
Bill of Materials
- Universal Rotor (Factor e Farm)
- Small lathe chuck (Factor e Farm)
- 1.5"x14"x1" hydraulic cylinder (Factor e Farm)
- Coupler - to go from 1-7/8 shaft to 1-1/4" shaft. 2" long on wider side, 1" long on narrower side
- [2] 3/8"x4"x6" angle, 44" long - verticals
- [4] 1/4"x1" angle, 20" long - rails for holding universal rotor to prevent it from twisting
- [2] 3/8"x4"x6" angle, 12" long
- [1] 3/4" threaded rod, 8"; [4] nuts - for top-facing end of cylinder
- [1] 3/4" threaded rod, 6"; [4] nuts - for bottom-facing end of cylinder