How to: Create Printer Cluster Image

Warning: This instructionals may be functional, but the provided files are not! The scanner is completely untested and the webserver is in a stage of heavy testing!!

This Page will have a full documentation on how the Printer Cluster Image is created, so it can be reproduced or modified. This will of course be an advanced process, so the reader should have a basic understanding about linux in general and SSH in specific.

Creating the Image

As a basic, we use Octopi, therefore our basic assumption is the use of the octopi image found here: Link

However, this set of rules should work basically on every Debian based system (like Ubuntu), some commands may need adjustment and of course there should be about the same folder structure regarding the location of octoprint and it's configuration folders. There is however nothing [ARM] specific involved so there is nothing strictly speaking against porting the system to a desktop or laptop.

For a manual on how to write the octopi to an SD card and connect it to the network look [How_to:Write_Image_to_SD_Card here]

The custom setup

After logging into the pi with SSH (basic credentials: pi, raspberry) we can start customizing the image to fit our needs. The credentials and data for setting up the Printer Cluster System are collected together in a zip found [File:PrinterClusterData.zip here].

This File contains a Readme with a full step by step manual on how the image Printer Cluster image was created additionaly to all files that are needed for the setup (the instructions are also listed below). For getting the files and readme onto the pi we may use wget, taking the file directly from the wiki. The command unzip (Name of the File) will then expand the content.

When the (command line) instructions of the readme or below are followed, we should have the system ready, after reboot it should recognize all attached 3d Printer.

Instructions

sudo raspi-config

   <-- Expand File System, Change User Password

sudo apt-get purge haproxy

sudo service octoprint stop

sudo apt-get update

sudo apt-get upgrade

sudo apt-get install screen htop apache2 (maybe as 2 commandspart) libapache2-mod-wsgi python-flask

sudo a2enmod wsgi

sudo rm /etc/apache2/sites-available/000-default.conf

   Place Files, the folder RepLabHUB gets placed in /var/www 
   The .conf file to /etc/apache2/sites-available/
   Lastly, the scripts folder in /home/pi/scripts

sudo a2ensite RepLabHUB

sudo service apache2 reload

sudo service octoprint start

sudo nano /etc/hosts

   --> change the line Octopi to RepLab