D3D Printer Dixon 1: Difference between revisions
Jump to navigation
Jump to search
(Created page with "=D3D 3d Printer Constructed September 2018= 14" Frame =Extruder= =Software= ==Cura Init== ==Marlin Firmware==") |
mNo edit summary |
||
| Line 1: | Line 1: | ||
= | [[3D_Printer_Manual]] | ||
=Frame= | |||
=Axes= | |||
=Heated Bed= | |||
=Control Panel= | |||
==Control Panel== | |||
==End Stops== | |||
==Cable Chain, Routing, etc.== | |||
=Extruder= | =Extruder= | ||
1.75mm Titan Aero | |||
Mounted via two 3mm rods assembled into 'bolts' using 6mm nuts, 3mm lock washers, and 3mm nuts through two vertical holes on the carriage piece. | |||
=Software= | =Software= | ||
==Cura Init== | ==Cura Init== | ||
==Marlin Firmware== | ==Marlin Firmware== | ||
Latest revision as of 02:41, 15 October 2018
Frame
Axes
Heated Bed
Control Panel
Control Panel
End Stops
Cable Chain, Routing, etc.
Extruder
1.75mm Titan Aero Mounted via two 3mm rods assembled into 'bolts' using 6mm nuts, 3mm lock washers, and 3mm nuts through two vertical holes on the carriage piece.