CEB Press/Manufacturing Instructions/Roller guides: Difference between revisions
Jump to navigation
Jump to search
m (→Tools Required) |
|||
| Line 10: | Line 10: | ||
== Materials Required == | == Materials Required == | ||
* | You need 2 roller guides. Each one requires the following: | ||
* | |||
* | Steel: | ||
*1/ | *1/2”x3”x12” plate (1) | ||
*1/ | *Spacer plate (1) (One roller guide will use a 3/8" thick plate, and the other will use a 1/2" plate)(these can be scrap, but need to be smaller than 3”x9.5”) | ||
*12mm V Groove | |||
Bolts: | |||
*1/2”x2” bolt (1) | |||
*12mm x 50mm bolts (2) | |||
Nuts: | |||
*1/2” nut (1) | |||
*12mm nuts (2) | |||
Washers: | |||
*1/2” washer (1) | |||
*1/2” lock washer (1) | |||
*12mm lock washers (4) | |||
Bearings: | |||
* V Groove bearing 12mm [http://www.vxb.com/page/bearings/PROD/Kit8406 Buy] | |||
== Diagrams == | == Diagrams == | ||
Revision as of 19:34, 11 August 2011
Main > Housing and construction > CEB Press > CEB press building instructions
Tools Required
- Hole punch or drill with 1/2” bit
- Welder
- Angle Grinder
Materials Required
You need 2 roller guides. Each one requires the following:
Steel:
- 1/2”x3”x12” plate (1)
- Spacer plate (1) (One roller guide will use a 3/8" thick plate, and the other will use a 1/2" plate)(these can be scrap, but need to be smaller than 3”x9.5”)
Bolts:
- 1/2”x2” bolt (1)
- 12mm x 50mm bolts (2)
Nuts:
- 1/2” nut (1)
- 12mm nuts (2)
Washers:
- 1/2” washer (1)
- 1/2” lock washer (1)
- 12mm lock washers (4)
Bearings:
- V Groove bearing 12mm Buy
Diagrams
Fabrication Steps
punch 1/2" holes:
- 3/8”x2”x8.5” (2) – 3” sep at center
- 1/2”x2”x3.5” (2) – 1” off end
- 1/2”x2”x4 3/4” (2) – 1” off end