CEB Press/Manufacturing Instructions/Frame with main cylinder

Main > Housing and construction > CEB Press > CEB press building instructions

Tools Required

• torch
• hole punch

Materials Required

• 6 inch heavy (7/16") u-channel - ( 20 ft )
• 3/4" x 2" Bolts (32))
• 3/4" Nuts (32)
• 3”x3”x1/2” (8) (cylinder mounts for both cylinders)
• 1” shaft, 6” long (main cylinder mount)
• 5 X 8 3000PSI Welded Cross-Tube Hydraulic Cylinder Buy

Fabrication Steps

Step 1: Cut pieces

Step 1. Torch or cold-cut channel to size

Cut the following pieces out of the 6 inch heavy (7/16") u-channel steel:

• A - 2 pieces, 44"
• B - 2 pieces, 28 3/4"
• C - 4 pieces, 20 3/4"
• D - 2 pieces, 9"

Cut the following pieces out of 1/4X2"X4" angle steel:

• E - 2 pieces 20 3/4"

Cut the following pieces out of 1/4" sheet steel:

• 2 pieces 10”x18” (bent (90 degrees???) 1.5” off the edge the long way)

Step 2: Punch holes

Step 2

• A - 1" from the tip of the edge, in the edges of 41 1/2" upright pieces at the following locations: 1", 5", 36.5", 40.5"(more to follow)
• B - Four holes in each of the 28 3/4" pieces such that they are 19.4" apart on the long axis and 4"(?not sure) apart on the short axis. They should form a centred rectangle parallel to each of the 26" pieces.
• C - Four holes in each of the 20 3/4" pieces such that they are 19.4" apart on the long axis and 4"(?not sure) apart on the short axis. They should form a centered rectangle parallel to each of the 18" pieces.
• D -
• E -

Step 3: Bolt pieces together

Step 3

Diagrams

Step 1: Gather the Form Pieces

Step 2: Put the Form Pieces Together

This diagram shows the pieces needed for the frame. Click to enlarge: