Steam Engine Planning: Difference between revisions

From Open Source Ecology
Jump to navigation Jump to search
Line 1: Line 1:
[[Image:monster_steam.jpg]]
[[Image:monster_steam.jpg]]


=Introduction=
=Concept Introduction=


Nick Raaum is project manager.
Nick Raaum is project manager. Our present concept is to use a single acting cylinder made from steam piping, using an electronically-controlled valve, and a position sensor that tells when the valve should open and close.


=Strategy=
=Strategy=

Revision as of 02:00, 8 December 2008

Monster steam.jpg

Concept Introduction

Nick Raaum is project manager. Our present concept is to use a single acting cylinder made from steam piping, using an electronically-controlled valve, and a position sensor that tells when the valve should open and close.

Strategy

On 12.6.08, Nick and Marcin had a strategy session in which we decided:

  • Pursue a simple, single-acting, steam engine with electronically controlled valve
    • Pursue stock pipe sections to eliminate casting requirements?

Electronics

  • Asco valve - 8 hz, 150 PSIg operating pressure solenoid steam valve - $100 new; one required
  • Programmable Logic Controller - Arduino board?
  • Position sensor - an optical sensor, photoelectric eye?

Materials

  • A56 Schedule 80 half inch piping, carbon steel