Cold Saw/V1 Design Parameters/Drive System: Difference between revisions
Jump to navigation
Jump to search
| Line 12: | Line 12: | ||
*'''Thickness: 25mm''' | *'''Thickness: 25mm''' | ||
*'''Drive Hole Diameter: 40mm''' | *'''Drive Hole Diameter: 40mm''' | ||
| Line 18: | Line 19: | ||
*'''Drive Hole Spacing Along Width: 40mm''' | *'''Drive Hole Spacing Along Width: 40mm''' | ||
*'''Motor Mount Hole Spacing Along Length: 20mm, 120mm''' | *'''Motor Mount Hole Spacing Along Length: 20mm, 120mm''' | ||
| Line 24: | Line 26: | ||
*'''Motor Mount Hole: 12mm''' | *'''Motor Mount Hole: 12mm''' | ||
*'''Interfacing Hole Spacing Along Length: 150mm, 180mm''' | *'''Interfacing Hole Spacing Along Length: 150mm, 180mm''' | ||
Revision as of 01:06, 21 May 2012
Hydraulic Motor
- Mount Hole Pattern: 40mm x 100mm
- Mount Hole Diameter: 12.7mm
Interface Plate
- Length: 200mm
- Width: 75mm
- Thickness: 25mm
- Drive Hole Diameter: 40mm
- Drive Hole Spacing Along Length: 70mm
- Drive Hole Spacing Along Width: 40mm
- Motor Mount Hole Spacing Along Length: 20mm, 120mm
- Motor Mount Hole Spacing Along Width: 20mm, 60mm
- Motor Mount Hole: 12mm
- Interfacing Hole Spacing Along Length: 150mm, 180mm
- Interfacing Hole Spacing Along Width: 20mm, 60mm
- Interface Hole: M12
Shaft Coupling
- Outside Diameter: 51.4mm
- Bore: 31.8mm
- Length: 75mm
- Setscrew Hole Diameter: (4mm Hex)
- Setscrew Hole Spacing Along Length: 25mm
Inside Plate
- Length: 75mm
- Width: 75mm
- Thickness: 12mm
- Drive Hole Spacing: 37.5mm, 37.5mm
- Pinhole Pattern from center: XXmm, XXmm
Outside Plate
- Length: 75mm
- Width: 75mm
- Thickness: 12mm
- Drive Hole Spacing: 37.5mm, 37.5mm
- Pinout Pattern from center: XXmm, XXmm
Spindle
- Outside Diameter: 1.25"
- Length: 75mm
- End Thread Length: 25mm
- End Thread: 1-1/4", 7 TPI
Blade
- Bore: 1.25"
- Diameter: 250mm
- Pinhole Pattern from center: XXmm, XXmm