Cold Saw/V1 Design Parameters/Support System: Difference between revisions
Jump to navigation
Jump to search
| Line 28: | Line 28: | ||
*'''Thickness: 25mm''' | *'''Thickness: 25mm''' | ||
=Support Shaft Collar= | =Support Shaft Collar= | ||
Revision as of 00:59, 26 May 2012
Shaft Block
- Length: 75mm
- Width: 50mm
- Height: 75mm
- Support Shaft Hole Diameter: 31.8mm
- Support Shaft Hole Spacing Along Length: 37.5mm
- Support Shaft Hole Spacing Along Height: 50mm
- Mount Hole Diameter: 12mm
- Mount Hole Spacing Along Length: 10mm, 65mm
- Mount Hole Spacing Along Width:25mm
Bridge Bar
- Length: 25mm
- Width: 75mm
- Thickness: 25mm
Support Shaft Collar
- Length: 30mm
- Outside Diameter: 60mm
- Bore: 31.8mm
- Setscrew Type: M12
Support Thrust Washer
- Outside Diameter: 60mm
- Inside Diameter: 35mm
- Length: 4mm