LifeTrac II Fabrication Procedure

From Open Source Ecology
Revision as of 21:23, 3 July 2010 by William (talk | contribs)
Jump to navigation Jump to search

Frame

As a general rule, all the measurements I have listed here will be more accurate if you mark the centre on each tube and then measure the "holes" from the centre our as opposed to from the ends in case some tubes are not cut the the exact lenghs.

  • [4] 92"×4"×4" Tubes for base.
    • 2 base tubes - 13/16" (V) holes 2" from ends. 1 (V) hole 4" front of centre. 4 (E,W) holes for wheel plates 9" & 13" from ends.
Retrieved from "https://wiki.opensourceecology.org/index.php?title=LifeTrac_II_Fabrication_Procedure&oldid=12705"