Hall Effect Sensor Module

Action Info

Materials

Hall Effect Sensor

Aluminum Bar 6061T6 1/4" x 1/2" x 72"

Silicone Caulk

22 AWG Stranded Wire of different colours

Cord jacket for 3 22AWG wires

Wire Label

---

Steps

• Cut 3 pieces of 22AWG wire and 1 piece of jacket to the desired length (ex. 150cm)

• Strip the 3 pieces of wire 10mm at one end and 20mm at the other end

• Check and confirm which pins of the hall effect sensor are to which inputs/outputs (ex. V+, V-, Signal)

• Solder and shrink tube the 10mm ends of the wires to the hall effect sensor pins and attach a label near the sensor to each wire about what the wire's pin is (ex. Red is V+, Black is V-, Green is Signal)

Developers

Yoonseo Kang - ykang404@gmail.com