LifeTrac II Part Sourcing

Cut List

Square tube:

• 4 × 7'8"×4"×4" tubes for base
• 3 × 5'×4"×4" under base tubes
• 2 × 52"×4"×4" vertical chassis centre tubes
• 2 × 55"×4"×4" vertical chassis tubes for front corners
• 2 × 59"×4"×4" vertical chassis tubes for rear corners (PC mounting area)
• 2 × 84"×4"×4" top chassis tubes
• 3 × 44"×4"×4" top chassis tubes

Rounds:

• 4 × 28"×1-7/8" axle shafts
• 4 × 54"1-7/8" loader shafts
• 2 × 100"×6"×2" front loader arm tubes
• 2 × 84"×6"×2" rear loader arm tubes
• 12 × 8" dom to mount loader shafts to loader arms.
• 1-7/8"bore bushing tubing to mount loader arm shafts to frame
• 1"bore tubing for 8 bushings to connect h/cylinders to loaders
• plate to mount bushings to loader arms

Plate:

• 12 × 10"×8"×0.5" steel plates to mount flange bearings and hydraulic motors to
• 2 × 12"×12"×1/2" plate to mount h/cylinders to base
• 4 × 32"diameter × 9" wheels
• 1/2"plate & 1-15/16"tubing to make wheel mounts

Bolts

• 32 × 3/4" bolts to span 4-1/2" space + nuts & washers to suit (for wheel plates)
• 42 × 3/4" bolts to span 8" space + nuts & washers to suit (for frame)
• 8 or 16 bolts for hydraulic plates to span 4-1/2" space + nuts & washers to suit

Surplus Center

• 8 × flange Bearings - [1]
• 2 × Front Loader cylinders - 36" - $174 - 48 5/8" retracted length - [2]
  • 4.9 square inch area at 2500 PSI implies 12000 lb of force for each cylinder
• 2 × Rear loader cylinders - [3]
• 4 × Motors - [4]
• 2 × 1-1/4" shaft couplers - [5]
• 1-3/8" 6T fully splined shafting - [6]
• 16 × 1.875" double split shaft collars - [7]