CEB Research 2015

CEB Press Research 2015 for CEB Rev 4.3 Build VI

CEB_Press_Molds Interchangable Press Molds This was addressed in

Increasing production rate; Enlarging the press to produce multiple blocks per cycle increases the production rate. Video example HydraForm V2LE

Eliminate shaker components. - steeper hopper sides - different hopper to press geometry - load with auger or conveyor - prepare a soil mix that performs better in the hopper

Insulating CEB (lightweight too) Consider mixing as much as 70% perlite, styrofoam or other closed cell insulator into the soil mix. This could be tested with one or two blocks pressed with various insulating materials and soil mixes. Test for shrinkage, compression capacity and R Value. Perhaps a composite block, half compressed earth and insulated compressed earth, might make a better exterior wall because of thermal mass on the inside and insulation on the outside.

Soil Auger

Soil Mixer

Interchangeable Parts at least in three variations 1- fully automatic, 2- power press, 3- full manual